NODEID = 00 E0 4C 68 00 01
;ENDID = 00 E0 4C 68 FF FF
;VID = 10 EC
;DID = 30 00
SVID = 1A 56
SMID = 30 00

;Do not change following parameters without Realtek approval
;CONFIG0 = 07
;CONFIG1 = CF
CONFIGx = 3C
;For add-on device, Please set CONFIG3 to 60H
;CONFIG3 = 60
;CONFIG4 = 14
;CONFIG5 = 02
;If PXE is enabled, set spi_en (IO reg offset 0x56 bit 3 set to 1) to 1
;CONFIG5 = 0A
;PMC = C3 FF
;ROMBAR = 00
;LEDXCFG = High-Byte Low-Byte
;LEDX Bit 11: Low power mode enable
;LEDX Bit 10: Preboot enable
;Please make sure CONFIGx LED low power bit enabled 
;(IO reg offset 0x53 bit 2 set to 0) before modifying LED low power mode or LED preboot
;LED0CFG = 02 01
;LED1CFG = 02 02
;LED2CFG = 02 08
;LED3CFG = 02 20
;LED Feature Functions
;Set BIT 0 to 0 : V1 led table.
;Set BIT 0 to 1 : V2 led table.
;BIT 1 to BIT 7 : Reserved
;LEDFEATUREFUNC = 60
ROMCONF = 3F
;Bit 7-6    Boot Protocol
;           00 ==> PXE protocol
;           01 ==> RPL protocol
;Bit 5-4    Boot order (method)
;           00 ==> ROM disable
;           01 ==> Int 18h
;           10 ==> Int 19h
;           11 ==> PnP/BEV(BBS)
;Bit 3      Show Config Message
;           0 ==> Enable
;           1 ==> Disable
;Bit 2      Shift+F10 Menu Entry
;           0 ==> Enable
;           1 ==> Disable
;Bit 1-0    Show Config Time
;           00 ==> 3 Seconds
;           01 ==> 5 Seconds
;           10 ==> 1 Seconds
;           11 ==> 0 Second

;Serial Number in PCI Config Space
SN = 00 E0 4C 68 00 00 00 01

;LANCFG 
;BIT 0:LAN Disable     BIT 1:PHY Disable    BIT 2:Link OK
;BIT 31:Clear LANCFG
;LANCFG = 00 00 00 00

;MDI swap
;MDI non-swap set to 00H, MDI swap set to 20H
;MDISWAP = 00

;Tx polarity swap
;BIT 7: P3 non-swap set to 0, P3 swap set to 1
;BIT 6: P2 non-swap set to 1, P2 swap set to 0
;BIT 5: P1 non-swap set to 0, P1 swap set to 1
;BIT 4: P0 non-swap set to 1, P0 swap set to 0
;BIT 0 to BIT 3 : Reserved
;TXPOLSWAP = 50

;DISFUNCXIOBAR = 00
VERSION = 1.031
